Bush-hammering plate for grinder TANGA 3 (non-slipt 3-10 cm) | Lupato

TANGA 3 | Bush-hammering plate for grinder Ø 110 mm | Non-slip 3-10 cm | Lupato

Tanga 3 is a bush-hammering plate designed to be easily applied to any type of mini angle grinder, specially designed for non-skid on marble, stone, granite and agglomerates It is ideal for bush-hammering tops, anti-slides, ribs and bulls-eyes

The Tanga 3 bush-hammer plate consists of 3 rollers, has a diameter of 110 mm with M14 connection, and has a non-slip width from 3 to 10 cm (to make wider non-slip from 5 to 13 cm there is the Tanga 4 bush hammer plate)

The Tanga 3 plate is available in 3 different models:

• Tanga 3/19 – For medium bush hammering on marble;

• Tanga 3/2W10 – for medium bush hammering on marble and fine bush hammering on granite;

• Tanga 3/1W20 -for fine bush hammering on marble and granite

The Tanga 3 bush-hammering plate is supplied without glide. In this mode the rollers work more aggressively. This skidless working mode is suitable when you need to make anti-skid strips and work straight edges.

If you have to bush-hammer on flat surfaces or bullnose, it is recommended to purchase the glide as with this glide the rollers are protected during machining and you have greater control of the tool by working precisely and evenly

ADVANTAGES:

– Easy installation and use on every kind of mini grinder
– Exploiting the advantages of the skid system
– Opportunity to work on thin or defective slabs
– Wide range of anti-slip widths and finishes
– Possibility of machining the 3 cm hedge

Rollers and replacement satellites for Tanga 3 can be supplied